CCNA2 CASE STUDY V6.1.1

IPsec protocols often perform integrity checks on packets when they are received to ensure that they have not been changed in transit from the source to the destination. When a customer purchases a Cisco IOS They automatically switch the path to the destination network when the topology changes. Protect — Packets with unknown source addresses are dropped until a sufficient number of secure MAC addresses are removed, or the number of maximum allowable addresses is increased. They automatically switch the path to the destination network when the topology changes. The other options do not put the switch port into trunk mode.

Similarly, Figure has 7 collision domains. They improve the efficiency of discovering neighboring networks. The output shows that there are two inside global addresses that are the same but that have different port numbers. The router will only forward packets that originate on directly connected networks. Posted on February 13, by Admin.

Cut-through switching does not perform any error checking.

The output of debug ip nat shows each packet that is translated ccan2 the router. Acting as a backbone is a function of the core layer.

ccna2 case study v6.1.1

They are numbered VLANs to Which port security configuration will meet these requirements? Protect — Packets with unknown source addresses are dropped until a sufficient number of secure MAC addresses are removed, or the number of maximum allowable addresses is increased.

  PROBLEM SOLVING PDST

CCNA 2: Case Study

The other options are irrelevant. Only frames with a broadcast destination address are forwarded out all active switch ports.

In addition to broadcast frames, frames with a destination MAC address that is not in stucy CAM are also flooded out all active ports.

When the destination device responds, the switch adds the source MAC address and the port on which it was received to the MAC address table. Create a Default route to the loopback Step 3: A network administrator is configuring a router as a DHCPv6 server.

ccna2 case study v6.1.1

What is the administrative distance value wtudy indicates the route for R2 to reach the Why is the configuration incorrect? However, PC1 is not able to receive an IPv4 address. The floating static route command ip route 0. Which route was configured as a static route to a specific network using the next-hop address? What is the most likely cause of the problem?

CCNA 2 v6 RSE Final Exam Answers All in One % – Premium IT Exam & Certified

The show mac-address-table and show port-security commands will display information that is more related to access layer operations. Static Routing Lab Report. Because NAT changes values in the headers as packets studg from inside to outside, these integrity checks can fail, thus causing the packets to be dropped ccnw2 the destination. Match the description to the correct VLAN type. Two of them are scalability and speed of convergence.

  SHOW MY HOMEWORK OAKLANDS

A management VLAN carries management traffic. Why is the configuration incorrect? Traffic will not be routed from clients with addresses between The keyword overload is used to configure PAT. Thus static routing improves network security because it does not make route updates among neighboring routers. The other options will not work, because the IP addresses defined in the pool, Which three items must be configured on the ccnx2 for the task?

Match the router memory type that provides the primary storage for the router feature.

Ccna2 case study v6.1.1

This can be done with the command Switch config-if switchport mode trunk. Static routes are manually configured on a router. A network engineer is examining a configuration implemented by a new intern who attached an IP phone to a switch port and configured the switch.

ccna2 case study v6.1.1

The administrator issues a show ipv6 dhcp pool command to verify the configuration.